Fowler's Mill
Fowler's Mill was constructed in 1833 by
brothers, Hiram and Milo Fowler. The mill building was built with timber from the Fowler's
land. The water to power the mill came from the Chagrin River and was channeled into a
center-discharging, turbine wheel that turned the French buhrstones and supplied the power
to run the mill's operation.
C. S. Johnson replaced the turbine with a huge wooden waterwheel in
1879. The overshot wheel measured 13 feet in diameter, 11 feet wide, and was built with
two sets of buckets. The French buhrstones were replaced in 1894 after 61 years of
grinding. In 1906, steam-power was introduced in the mill but was not successful and
waterpower was quickly reinstated.
The mill ceased operating from July 17 through October 17, 1907, to
install $2,600 worth of modern equipment. An overshot, steel waterwheel was installed in
1911, replacing the wooden wheel. With the steel waterwheel, the mill produced 35 bushels
a day. In 1947, George Denniston installed an electric hammer mill to grind animal feed.
Fowler's Mill ceased operation in January 1966 and sat unoccupied until
1986. The new owners Billie and Rick Erickson restored and reopened the mill in 1989. They
are grinding with two electric-powered stone grinders purchased from an old mill in
Georgia. The Fowler's Mill can produce 700 pounds of ground grain per hour and currently
supplies a local market as well as a national mail order market.
Self-guided tours are available on Saturday and Sunday. The mill store
is open Wednesday through Sunday all year. Stone ground corn, wheat and rye are ground to
produce pancake, muffin, cookie, shortcake, and cobbler mixes. Over 300 gourmet food
stores carry the Fowler's Mill premium baking mixes, flours, and corn meal.
Fowler's Mill is a wonderful experience. You will find, "a
preserved historic mill, antique milling equipment, and stone grinding." Today
Fowler's Mill is a 2 1/2-story frame structure supported by a full cut stone basement and
foundation. The front and side windows are 6 over 6 double-hung. The rear windows are
single panes, double-hung. The wood frame structure is covered with lap siding painted
dark red with white trim. The back of the building is white.
"Through actively producing stone-ground products....the tradition
of milling continues," Billie Erickson comments. Fowler's Mill is one of a few
remaining old mills in Ohio that has been restored and placed into production. Everyone
who admires and respects old historic structures appreciates the efforts of Billie and
Rick Erickson and the restoration of Fowler's Mill. ("Couple's Old World Method Gives
Fowler's Mill New Life."; Erickson, Billie; "Fowler's Mill"; Johannesen;
"Old Mill at Fowler's Mill.).
DIRECTIONS: Geauga County. Munson Township. From Chardon, S.R. 44
south, 3 miles, left (west) on S.R. 322, 3.5 miles, right (north) on Fowler's Mill Road,
.1 mile, on left, in Fowler's Mill.
OWNERS OF FOWLER'S MILL
(dates unknown)
Hiram and Milo Fowler
Walter and Henry Stannard
John Ford
C.A. Miller
Delos Avery
C.J. Coleman
C.S. Johnson
C.J. and Spencer Coleman
A.D. Carroll
Fred Hovey
Louis Rericha
Ferdinand Kobliha and Klement Buchta
Ferdinand Kobliha
Lillian K. and George Denniston
1887 Gardener Stickney rented the mill
1890 Everett Manley rented the mill
1900 Milo Aiken rented the mill |